Cara Memasang Saklar Double Merk Broco

>Hello Sohib EditorOnline, in this journal article, we will discuss the step-by-step guide on how to install a double switch from Broco brand. A double switch is a common electrical component used in homes and buildings to control two separate lights or electrical devices with just one switch.

What You Will Need

Before we start, let’s prepare all the materials we will need for this project:

Step-by-Step Guide

Now that we have all the materials we need, let’s proceed with the installation process:

Step 1: Turn Off the Power

Before starting any electrical project, make sure to turn off the power source to prevent electrocution. Locate the circuit breaker that controls the electrical circuit where you will install the double switch. Turn off the breaker and use a voltage tester to confirm that there’s no electricity flowing to the wires.

Step 2: Remove the Old Switch

Remove the cover plate of the old switch using a screwdriver. Unscrew the switch and gently pull it out of the electrical box. Use a voltage tester again to make sure that there’s no electricity flowing to the wires.

Step 3: Disconnect the Wires

Take note of the wires connected to the old switch. There are usually three wires: one black wire, one white wire, and one green or bare wire. Use a wire cutter to disconnect the wires from the old switch.

Step 4: Prepare the Wires

Strip the ends of the wires using a wire stripper to expose about half an inch of copper wire. Twist together the black wires from the two electrical cables that enter the box. Do the same for the white wires and the green/bare wires.

Step 5: Connect the Wires to the Double Switch

Take the Broco double switch and connect the wires to their corresponding terminals. Usually, the black wires are connected to the brass-colored terminals, while the white wires are connected to the silver-colored terminals. The green/bare wires are connected to the green-colored terminal. Secure the wires using wire connectors.

Step 6: Install the Double Switch

Push the double switch into the electrical box and secure it using screws. Attach the cover plate to the switch using screws as well.

Step 7: Test the Double Switch

Turn on the circuit breaker and test the double switch by flipping it up and down. Make sure that both lights or devices connected to the switch turn on and off simultaneously.

FAQs

1. Is it safe to install a double switch on my own?

If you have basic knowledge of electrical wiring and follow the instructions carefully, installing a double switch can be done safely. However, if you’re not confident in your skills, it’s best to hire a licensed electrician.

2. Can I use a double switch to control two separate circuits?

No, a double switch can only control two separate devices or lights that are connected to the same circuit. For separate circuits, you need two single switches.

3. What are the color codes of electrical wires?

Black wires are usually the “hot” wires that carry electricity, white wires are the “neutral” wires that complete the circuit, and green/bare wires are the “ground” wires that provide the connection to the earth.

4. What should I do if I encounter problems during the installation process?

If you encounter any problems during the installation process, stop immediately and consult an expert. Continuing the project when you’re not sure of what you’re doing can lead to serious accidents.

5. Can I use a different brand of double switch?

Yes, you can use a different brand of double switch as long as it has the same specifications and ratings as the Broco double switch.

That’s it! We hope this guide has been helpful for you in installing your Broco double switch. Remember to always prioritize your safety and follow the instructions carefully. Happy DIY-ing!

Cara Memasang Saklar Double Merk Broco